Compsee Apex III Manual de usuario descargar pdf (Pagina 22)

Terminal Setup

PowerNet

Keypress to Continue

Note: The date of 2006 is updated on the terminal at the time of a new release.

The terminal is now ready to establish a Telnet session with the host system.

Starting a Telnet Session

At the PowerNet main menu on the terminal, press any key to establish the connection.

Until the terminal has been authorized, the following screen is displayed.

RECOVERABLE ERROR

Terminal not

Authorized for

PowerNet

Keypress to Continue

It is not necessary to authorize the terminal at this time, so press any key to continue. The

terminal will establish a connection with the host system and start emulation. If the

terminal fails to connect to the host, refer to the following table for the possible causes

and the related corrective actions.

Failure Cause Corrective Action

Incorrect Host IP address Correct the Host List address on the terminal. Refer to the

sub-section Terminal Setup Using PowerNet Menus for

instructions.

Incorrect netmask value Access Radio Setup menu and correct the netmask value.

Refer to the sub-section Terminal Setup Using PowerNet

Menus for instructions.

After a Telnet session has been successfully established, the terminal will remain in

session for a maximum of 30 minutes at a time until it has been authorized. Once

authorized, there is no software restriction on the session time. The instructions for

authorizing the terminal are presented in the Authorizing PowerNet section.

Supported Equipment Manual

•

May, 2006

2-14

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 73 74

Sin comentarios

Compsee Apex III Manual de usuario Pagina 22