National Sales Office
2500 Port Malabar Blvd. NE
Palm Bay, FL 32905
800-628-3888 – V
321-724-4321 – V
321-723-2895 – F
Corporate Headquarters
400 N. Main St.
Mt. Gilead, NC 27306
2
Warranty Limitations
Prior to operating the terminal, review the following warranty limitations. Failure to adhere to the provisions of these
limitations will void the product warranty.
DO NOT attempt to open or disassemble the Apex except as directed for a specific operation by this or other Apex
manuals (e.g. End Cap Removal). No user serviceable parts are included in the unit.
Charge the Battery Pack only with an approved Compsee charging device. Use of any charging device other than those
specified by Compsee can potentially damage the Apex or Battery Pack.
DO NOT spray cleaners directly on the keypad or use a saturated cloth for cleaning the unit. Only a lightly damp cloth
should be used for wiping down the unit.
DO NOT clean the Apex using alcohol, acetone, mineral spirits or any other petroleum or alcohol based product.
Damage to the unit can occur.
DO NOT leave the unit in the rain or direct sunlight or immerse the unit in water or any other liquid.
Use only Compsee cables for data transfer purposes. Attachment of other cables may cause damage to the unit and/or
the attachment device.
Recommended Operational Tips
Note: Failure to heed the following recommendations, while not voiding the warranty, may result in operational
degradation or program/data loss.
DO NOT clean the Laser Window, Display Screen Window, or IR Window with soap, abrasives, or any alcohol or
petroleum based solution.
DO NOT attempt to operate an Apex PDT once it has powered down due to a low battery condition. When the
Battery Pack is exhausted, leave the exhausted Battery Pack in the Apex until you can either charge it in place by placing
the Apex III in the Apex III Dock or swap out the Battery Pack with a fully charged Battery Pack. Information in volatile
memory (RAM) will be preserved since the Apex PDT is configured so that even with an exhausted Battery Pack enough
energy is retained to maintain the information for an extended period of time. DO NOT leave the unit WITHOUT a Battery
Pack for more than 5 minutes.
The Apex III PDT and Apex IV PDT Battery Packs are of Nickel Metal Hydride (NiMH) and Lithium – Ion (Li-Ion)
composition respectively. The Battery Packs DO NOT succumb to memory (hysteresis) loss as do Nickel-cadmium (Ni-Cd)
batteries. Therefore, Apex PDT Battery Packs can be charged while in any state-of-charge and do not require a full
discharge prior to charging. With the Apex III Battery Pack, it is still recommended that the Battery Pack be fully
discharged periodically to reset the internal gas gauge circuitry.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales